How to top up:

• Unscrew your ETS Glassomizer from your battery

• Whilst holding the clearomizer with the mouthpiece facing down, unscrew the base with the coil still attached to the base

• Pour your chosen liquid inside the tube, pouring down the sides - NOT down the middle hole

• Avoid overfilling so that no liquid can go down the centre hole

• Screw the base back on to the tube

• Roll the clearomizer around and let the e liquid absorb for a few minutes - or you may end up burning the coil

• Vape away!

How to change the coil:

• If you getting a burning taste and there is still liquid in the tank then the coil needs replacing.

• Changing the coil is best done with an empty tank, but just in case there is any liquid, ensure your Glassomizer’s mouthpiece is facing down to the floor.

• Unscrew your Glassomizer from your battery

• Unscrew the base Unscrew the coil from the base

• Screw in a fresh coil to the base

• Screw the base with the fresh coil back on to the tube

• Finally, screw the whole unit back on to the battery and you’re set to go.

How to clean:

Whilst all the pieces of the unit are separated when you change the coil, you can also clean your tank.

• You can unscrew the mouthpiece from the tank (meaning you can also swap this for any 510 drip tip).

• Run water through the mouthpiece and also the tank where the liquid goes.

• Leave to dry and voila - fresh like new!

• If you experience any gurgling this may be due to liquid getting into the centre airflow tube from filling incorrectly. Clear this liquid by blowing through the mouthpiece into a paper towel.

 

Evapezone Gloucester. Gloucester's Vape shop.